Hook up kitchen faucet

After installing your new faucet as detailed below, remove the aerator from the faucet and flush the lines to ensure that any debris does not clog and reduce the water flow.


  • traditional dating definition.
  • How to Install a Touchless Kitchen Faucet.
  • best dating website hosting.
  • singles dating site in south africa?
  • How to Install a Kitchen Faucet.
  • chemistry dating websites.

On a standard faucet, simply unscrew the aerator at the end of the spigot and let the water run for a minute or two. Many manufacturers include a special long socket specifically to aid in tightening the mounting nuts.

How to Replace a Kitchen Faucet

A hole in the socket accepts the shank of a screwdriver, guiding it as you tighten the nuts. Use an adjustable wrench to tighten the connection. Most pullout sprayer faucets and faucets with separate sprayers come with a counterweight that attaches to the sprayer hose. If necessary, gently bend the copper tubes coming out of the faucet for better access and connect flexible supply tubes to them. Simply wrap a couple of turns of pipe-seal tape around the threaded nipples on the valves and connect the tubes. Tighten the nuts with an adjustable wrench.

How to Install a Kitchen Faucet

Call for free estimates from local pros now: How to Install a Kitchen Faucet was last modified: Remove old faucet, then thread the data cable, hoses, and shank of the new faucet through the deck gasket. Align to the bottom of the faucet body. Then insert the cable, hoses, and shank through the mounting hole. If there are multiple holes, install the deck plate. Make sure the faucet handle is on the right side and the spout is facing you before moving on.

How to Install a Kitchen Faucet

Under the sink, slide the support plate over the cables, then slide the mounting washer onto the faucet shank. Make sure the data cable and hoses are within the curve of the washer.


  • top dating sites for single moms!
  • absolute best dating site!
  • interracial dating in iowa!
  • Inspiration. Ideas. How-To Advice.!

Thread the mounting nut onto the faucet shank, then make sure the faucet is correctly positioned on the counter or sink. Tighten nut with provided installation tool. Insert the screwdriver through the holes at the bottom of the plate. It makes tightening easier.

INSTALLING A KITCHEN FAUCET - HOW TO

Install the hose bracket about 2 inches from the end of the connecting hose. Slide bracket onto the end of the faucet, and secure in place with a hose-guide nut. Guide into the faucet spout. Remove the protective cap on the end of the hose, and connect it to the faucet with quick-connect lines. Simply press, clip, and listen for an audible click that indicates a secure connection. Connect the hoses and supply lines by identifying the corresponding inlets on the control box.

Kitchen Faucet Installation Guide

Remove protective caps on the hoses and push each into place. Pull lightly to make sure each hose is secure. Connect the hot- and cold-water supply lines. Secure the connection with an adjustable wrench—it should be snug but not overtightened. Attach cold side the same way. Make sure you're connecting the right water hoses to the right inlets. To differentiate between the two, note that the hot-water supply line has a white tag.

How to Replace a Kitchen Faucet

Install the control box by snapping it to the hose-guide nut. If you're mounting the control box to the cabinet base, install it where the data cable and hoses can reach. Attach spray wand to the pull-down hose by removing its protective cover and making sure the rubber washer and screen are in place. Thread the spray wand onto the pull-down hose, and tighten with an adjustable wrench until the hose nut is flush with the wand. Be careful not to overtighten.

Find the white mark on the pull-down hose and install a weight just below it.